Back from the Dead; '81 Scarab 38 Resto
#281
VIP Member
VIP Member
Thread Starter
#283
VIP Member
VIP Member
Thread Starter
#285
VIP Member
VIP Member
Thread Starter
Got it a fair amount done today, was able to put two layers of glass on the rt inner cabin stringer, and put a second layer on the lt inner cabin stringer. Then put some core bond on top of the stringers and braces where the cabin settee’s are. Cut out and glassed in some 1/2” plywood. Also tabbed some on the #2 bulkhead..
Last edited by hblair; 12-30-2017 at 07:40 PM.
#286
VIP Member
VIP Member
Thread Starter
#287
VIP Member
VIP Member
Thread Starter
Went back and fiberglassed the rear cabin rt side stringers. I’ll try to put another layer on them tomorrow. And possibly get the horizontal pieces glassed in top of them.
On all these stringers I’m tabbing them in place, then going back and fiberglassing them twice with 1708 fiberglass. So there’s two layers on the stringer and three layers of glass where the joint is. This boat will be very strong and lighter than when it was new.
On all these stringers I’m tabbing them in place, then going back and fiberglassing them twice with 1708 fiberglass. So there’s two layers on the stringer and three layers of glass where the joint is. This boat will be very strong and lighter than when it was new.
#288
VIP Member
VIP Member
Thread Starter
#289
Gold Member
Gold Member
Oh yeah, the fiberglass warrior Shon showed up and helped me today. Round of applause for Shon...
Attachment 573937
Attachment 573937