SSM #4 drives and Gimbals/transom assemblies
#21
Registered
Thread Starter
![Default](/forums/images/icons/icon1.gif)
I still have the IV`s . One is at collabellas getting new gears.. $10k for drives/spacers only . I do know of some transom assemblies if needed. Props are gone.
Edit:
RH drive will have new upper (straight cut forged) and lower gears.
Transom assemblies :
These are available (painted purple) $3500 fresh water since new:
![](https://cimg6.ibsrv.net/gimg/www.offshoreonly.com-vbulletin/768x1024/80-img_2271_1547680689157_61fa40cca2a1439139762b929d92f13fb359e76a.jpg)
Fresh Huber 1200 plug in with cryptonite shaft also available
Edit:
RH drive will have new upper (straight cut forged) and lower gears.
Transom assemblies :
These are available (painted purple) $3500 fresh water since new:
![](https://cimg6.ibsrv.net/gimg/www.offshoreonly.com-vbulletin/768x1024/80-img_2271_1547680689157_61fa40cca2a1439139762b929d92f13fb359e76a.jpg)
Fresh Huber 1200 plug in with cryptonite shaft also available
Last edited by ICDEDPPL; 01-16-2019 at 05:37 PM.
#24
Registered
Thread Starter
![Default](/forums/images/icons/icon1.gif)
Drives are 1.48 ratio.
#27
Registered
Thread Starter
![Default](/forums/images/icons/icon1.gif)
As the description says :
Not sure on the upper ratio but I can ask. lower is 1.25
LH has 26 spline big shaft RH has a 19 spline new shaft ( I use the 26 spline Arneson adapter)
#28
#29
Registered
Thread Starter
![Default](/forums/images/icons/icon1.gif)
Sent