Joe

We will be in Sarasota for sure... and uncertain whether i will be leaving it in sfl or bringing it back for labor day on lake travis, located in austin, tx (which you might want to check out). not a "haul azz" spot, but a bunch of good people and some clear, fresh water w/ a ton of fun!

i don't ever seem to make it to texoma, but you can speak w/ several folks here on the board, namely, txspeedfreak, which are my friends, Kelli and David. david mentions there are several cats there... and i know zane just bought an mti, which i imagine will be there by then...

joe

bidpro

1.35 is the ticket. Have used it on several setups similar to yours.

Gregg Reichman

32agitator

32 skater AGITATOR 1100 hp blown 15 PSI BOOST 1.25 #5 32 pitch 3 blades 7500 rpm 148 gps accelrates so hard it a rush cant wait to start blastin it again seeya

Brad Zastrow

Three blades? That is why you are running 20% slip. I normally run four blades or five blades on my 32 Skater. Five are the best but have a little too much stern lift on that small cat. I have a set of 30 four blades for sale that would be perfect on your boat. 16.5 x 30 should put you at 150-160 mph with even more punch.

Go with the 1.35 gears on your 36. Bill is right 1.24 take a lot of power. I have tried 1.24, 1.35 and even 1.5 gears on Number sixes and the 1.35 is nice setup.

32agitator

you think so i had a set of 17x31 4 blades and man we were way to loose with stern lift how much do you want for those props and were they the ones that leon had on that boat with his big power if so my 32 would be off the hook send me a pm

GATORONE

17" diameter is way to much on a cat... Should be running 16-16.5 on the diameter....the larger the diameter the more transom lift you will get

RunninHotRacing163.1

were they the ones that leon had on that boat with his big power : Do the math BIG Daddy

Brad Zastrow

Yes they were on "B'Yond reason"
Sent you an email with the ad link for the props.
http://www.offshoreonlyclassifieds.c...o24335-en.html

RunninHotRacing163.1

Brad these ran the shootout at 162 ?????
FYI your classified add says 15.5 diameter may want to check it out Hey BIG Daddy got any 39 or 40 5 blades 16.5 or 16" layin around ????

RunninHotRacing163.1

BIG Time Plumberscrack if ya need a nother set of 4 blade 36s just back from B Blades for spares let me know