36 Skater Project
08-06-2015, 08:38 PM
#1011
Platinum Member
Platinum Member
Before the day was over I was able to get a couple of engines hung
08-06-2015, 09:00 PM
#1012
Platinum Member
Platinum Member
Check the clearance between the cowlings
08-06-2015, 09:31 PM
#1015
Platinum Member
Platinum Member
We wont be there this year Sam, are you going to run in the shootout?
08-08-2015, 08:42 AM
#1016
Platinum Member
Platinum Member
With enough boat life 2 part loaded and ready in the caulk guns I proceeded to apply liberal amounts of caulking to the mating areas of the transom, aluminum plate and jackplate mating surfaces
I was working by myself and had to work with a sense of urgency due to the cure times of the 2 part sealant. Eventually I got it done
I was working by myself and had to work with a sense of urgency due to the cure times of the 2 part sealant. Eventually I got it done
08-08-2015, 11:21 AM
#1018
Not this year. I have not had time this summer to dial it in. Too many commitments. I did see 97.5 with my bravo props with 4 on board and 3/8+ tanks. It's at Boat Customs for bottom blue printing final clearcoat and some additional hardware. I'll be at Camden with my wife this year I was hopeful the wives could meet.
08-08-2015, 08:36 PM
#1019
Platinum Member
Platinum Member
Not this year. I have not had time this summer to dial it in. Too many commitments. I did see 97.5 with my bravo props with 4 on board and 3/8+ tanks. It's at Boat Customs for bottom blue printing final clearcoat and some additional hardware. I'll be at Camden with my wife this year I was hopeful the wives could meet.
Are you going boatless this year or will your skater get finished in time to have it there to.just have fun driving around?
Last edited by davidmercury; 08-08-2015 at 08:42 PM.
08-08-2015, 08:39 PM
#1020
Platinum Member
Platinum Member
