36 Skater Project
#651
Platinum Member
Platinum Member
thanks guys, Going by in the video probably close to 95, and I didn't know that the rev limiter was released yet. We kept going and it was an awesome sight to look down and see the needles on all four tachs leaning way over towards 8000 range. we ended up with what you see on the speedo recall.
I'm ready to start dialing in now, the props I have on now are a just what I threw on to get her on the water. The 2 center ones are thick bladed15X34 stock merc cleavers off the shelf and need blueprinted
The outside motors are spinning 15X32 stock cleavers. Your help would be appreciated
[ATTACH=CONFIG]507668[/ATTACH][ATTACH=CONFIG]507669[/ATTACH]
I'm ready to start dialing in now, the props I have on now are a just what I threw on to get her on the water. The 2 center ones are thick bladed15X34 stock merc cleavers off the shelf and need blueprinted
The outside motors are spinning 15X32 stock cleavers. Your help would be appreciated
[ATTACH=CONFIG]507668[/ATTACH][ATTACH=CONFIG]507669[/ATTACH]
Last edited by davidmercury; 09-08-2013 at 04:52 PM.
#652
Platinum Member
Platinum Member
thanks guys, Going by in the video probably close to 95, and I didn't know that the rev limiter was released yet. We kept going and it was an awesome sight to look down and see the needles on all four tachs leaning way over towards 8000 range. we ended up with what you see on the speedo recall.
I'm ready to start dialing in now, the props I have on now are a just what I threw on to get her on the water. The 2 center ones are thick bladed15X34 stock merc cleavers off the shelf and need blueprinted
The outside motors are spinning 15X32 stock cleavers. Your help would be appreciated
[ATTACH=CONFIG]507668[/ATTACH][ATTACH=CONFIG]507669[/ATTACH]
I'm ready to start dialing in now, the props I have on now are a just what I threw on to get her on the water. The 2 center ones are thick bladed15X34 stock merc cleavers off the shelf and need blueprinted
The outside motors are spinning 15X32 stock cleavers. Your help would be appreciated
[ATTACH=CONFIG]507668[/ATTACH][ATTACH=CONFIG]507669[/ATTACH]
#657
Platinum Member
Platinum Member
Thanks guys, at least I'm on my way to get to my goal. I'll start experimenting with different propellers and engine height. The fun begins!
#658
Registered
Join Date: Apr 2007
Posts: 3
Likes: 0
Received 0 Likes
on
0 Posts
Hello David: My name is Jorge Cintron, we have a Mercury shop in Puerto Rico.Our boat is a Motion 35 with 3 280s.If you sent us your email adress
we can sent you photos of our boat and rigging.You have done a beautiful job with your Skater.Sincerely yours; Jorge Cintron.
[email protected]
we can sent you photos of our boat and rigging.You have done a beautiful job with your Skater.Sincerely yours; Jorge Cintron.
[email protected]
#660
Platinum Member
Platinum Member
Thanks Jorge, your Motion sounds like a cool set up. I'd like to see photos