32 Skater Custom Paint By Scott Eller Design
#41
Registered
Thread Starter
Join Date: Feb 2010
Posts: 974
Likes: 0
Received 0 Likes
on
0 Posts
Can you beat the 25 K Noli offered ?? I paid 23 K and worked pretty much non-stop for three years !! Shaun( STR ) is just finishing up my lowers and my 375 Stokers are ready to come home . How much HP per engine were you running and how fast with this pile of crap ? I figure 105 with pair of 375 HP efi stokers
Larry
Larry
#42
Platinum Member
Platinum Member
That is all cool stuff!
#46
Driver-441
Racer
Can you beat the 25 K Noli offered ?? I paid 23 K and worked pretty much non-stop for three years !! Shaun( STR ) is just finishing up my lowers and my 375 Stokers are ready to come home . How much HP per engine were you running and how fast with this pile of crap ? I figure 105 with pair of 375 HP efi stokers
Larry
Larry
#47
Registered
Thread Starter
Join Date: Feb 2010
Posts: 974
Likes: 0
Received 0 Likes
on
0 Posts
A few people asked how I move this hunk of crap around , here is a pic . 16x 10 x 1/4 alum with a few layers of closed cell foam rubber . The 2x 4 wood is just a simple link right to left side . This dolly is only used to paint deck as the bottom of sponson is 1 inch off ground . When paint is complete boat will go back on standard boat dolly
Painted my composite shifter arch which I made , it has cast in stainless inserts so that there are no visable screws .
The trailer is almost ready to send to Galvanizing but I have to make a few changes , like drill 85 5/8 relief holes so that pre-wash and then 850 degree Zinc ( hot dip galv ) can flow through . The ladder is an issue because I'm going to flip traler over to drill some holes so I cut ladder posts and welded on [re-drilled plates so that after galv it can bolted together . In the pic plate was in mock-up and not squared up
Larry
Painted my composite shifter arch which I made , it has cast in stainless inserts so that there are no visable screws .
The trailer is almost ready to send to Galvanizing but I have to make a few changes , like drill 85 5/8 relief holes so that pre-wash and then 850 degree Zinc ( hot dip galv ) can flow through . The ladder is an issue because I'm going to flip traler over to drill some holes so I cut ladder posts and welded on [re-drilled plates so that after galv it can bolted together . In the pic plate was in mock-up and not squared up
Larry
Last edited by KEVLARKAT32; 06-29-2011 at 10:39 AM.