Just Signed Up! Y2k Me Too!
#472
VIP Member
VIP Member
Thread Starter
Re: Just Signed Up! Y2k Me Too!
__________________
Gary H...
Gary H...
#474
VIP Member
VIP Member
Thread Starter
Re: Just Signed Up! Y2k Me Too!
__________________
Gary H...
Gary H...
#476
Gold Member
Gold Member
Re: Just Signed Up! Y2k Me Too!
Gary Wazz up Got The Boat Off The Trailer And On The Ground.I Put The ITS Box In And Made All The Steering Lines Up And Put Them In .Hooked Up All The Trim Pumps And Wired Them Up, Fuel Fill And Vent ,. Tomorrow I Am Gunna Put The Dummy Motor In And Make Up The Mounts So I Can Get Them Off To The Powder Coater. Then I Can Finish The Rest Of The Stuff In The Bilge . Ill Give U An Update Tomorrow LATER DUDE
#477
VIP Member
VIP Member
Thread Starter
Re: Just Signed Up! Y2k Me Too!
Thanks for the update John! Rolls axle is sending some carpet and some spacers for the final tweeking while the boat is off the trailer. I called to remind JC about the sheath that he and I came up with to protect the fuel fill hose and ground wire, cause as I mentioned to you, I'll be sliding the bimini support in and out of that area and dont want it to get hung up in any way or pull the ground wire off. Where are you putting the cockpit lighting and the engine compartment lights?
__________________
Gary H...
Gary H...
#478
T-Mone
Platinum Member
Re: Just Signed Up! Y2k Me Too!
Gary the boat looks awesome. Best of luck with it you must be going nuts counting the days until you can hammer down on her. I would love to see the boat when you get it back to Danbury. Take care, Anthony
#479
VIP Member
VIP Member
Thread Starter
Re: Just Signed Up! Y2k Me Too!
Anthony, my cell# is 203-240-1409. Feel free to call me anytime. If you want, PM me with your cell # so that we can hook up sometime. I'd love to show you her when I get her, maybe go for a rip together sometime! Sh!t your so close...We gotta hook up!
__________________
Gary H...
Gary H...
#480
Gold Member
Gold Member
Re: Just Signed Up! Y2k Me Too!
Motor Mounts All Made Got About 3/4sOf The Bilge Rigged By Thursday I Should Be All Done In The Bilge Back To The Dash And Finish Up All The Loose Ends If Everything Goes Good The Middle Of Next Week Should Not Be A Problem I Bet This Boat Goes 84mph no problem hey gary wouldnt that be a kick in the ass
Last edited by lightspeed; 08-02-2005 at 06:14 PM.