36' Y2k
#71
Registered
Re: 36' Y2k
Ok 36 Is A Bit On The Large Side How About Making It A 33? Just Long Enough For Another Motor And One More Step.the 30 Already Has Room In Front Of The Motor So 3ft Is About The Number.any Way To Make One Mold With An Insert For Both Boats?
#73
VIP Member
VIP Member
Re: 36' Y2k
Back to my 24' with extension box idea:
I was poking around Imco's web sight yesterday...
The extension box, drive shaft, wing plates, and... adds up to about $2K.
That's is the cost if my steering rams will work.
The K-plane 380 plates are around $800...
Shorter drive lower $?
I am not likely to buy new parts, so if I can accumulate everything used for around $2500, I think it would be worth a try...
I was poking around Imco's web sight yesterday...
The extension box, drive shaft, wing plates, and... adds up to about $2K.
That's is the cost if my steering rams will work.
The K-plane 380 plates are around $800...
Shorter drive lower $?
I am not likely to buy new parts, so if I can accumulate everything used for around $2500, I think it would be worth a try...
__________________
Patrick
Patrick
#74
VIP Member
VIP Member
Re: 36' Y2k
Go for it...A 24 SB s-t-r-e-t-c-h....
I am also considering a drive shower for the xr drive...I know the xr has a finned billet cap. Who makes a nice billet or stainless shower for that application?
I am also considering a drive shower for the xr drive...I know the xr has a finned billet cap. Who makes a nice billet or stainless shower for that application?
__________________
Gary H...
Gary H...
Thread
Thread Starter
Forum
Replies
Last Post
zimm17
Superboat
39
08-01-2006 11:42 AM