Mirage Plus 21p Rh & Lh
#22
Registered
Thread Starter
No problem.. I just hate to break the set & sell the Rt. hand & then take a chance on being stuck with a single Lh. b/c sometimes they can be harder to find a home for.... However If you say you are wanting the Lefty I will take my chances & go ahead & sell the Rt. hand to Rick (rchevelle71) Leaving the Lt. hand for you if you think you will take it in a week or two ??
#25
Registered
Thread Starter
I had good intentions of that if it counts for anything..
I was going to go ahead & have it completly boxed up & ready to label & I realized that I didn't have any expandible foam to shoot in the box after wraping the prop in plastic... ( I don't trust shipping carriers to much) Anyways I went to lowes this evening & got a few cans so I should be able to do it tommorrow... Sorry for the delay !
I was going to go ahead & have it completly boxed up & ready to label & I realized that I didn't have any expandible foam to shoot in the box after wraping the prop in plastic... ( I don't trust shipping carriers to much) Anyways I went to lowes this evening & got a few cans so I should be able to do it tommorrow... Sorry for the delay !
#26
I had good intentions of that if it counts for anything..
I was going to go ahead & have it completly boxed up & ready to label & I realized that I didn't have any expandible foam to shoot in the box after wraping the prop in plastic... ( I don't trust shipping carriers to much) Anyways I went to lowes this evening & got a few cans so I should be able to do it tommorrow... Sorry for the delay !
I was going to go ahead & have it completly boxed up & ready to label & I realized that I didn't have any expandible foam to shoot in the box after wraping the prop in plastic... ( I don't trust shipping carriers to much) Anyways I went to lowes this evening & got a few cans so I should be able to do it tommorrow... Sorry for the delay !
#27
Registered
Thread Starter
I may not have been clear enough in my first post but the hubs in these props are for a 1 1/4" XR shaft...
I may not have been clear enough when I said XR hubs included...
Sorry for any confusion..
I may not have been clear enough when I said XR hubs included...
Sorry for any confusion..