Merlin Cast Iron Heads
#1
Registered
Thread Starter
Merlin Cast Iron Heads
One Pair of Merlin Cast Iron Grumpy Jenkins Series Heads. BBC MARK IV HEADS ready to bolt on. They have six minutes run time on dyno, Bronze guides, Hardin valve seats, manley severe duty stainless 2.30 intakes, inconel 1.88 exhaust, 345 intake runner, 3/8" valve stems. Set up without valve seals, but have them if you want to use them.
Springs set up for hydraulic roller cam with 150-160 seat pressure. Heads have the extra holes drilled for the inside head bolt for the Merlin or Dart blocks. $ 1300., plus shipping. Not using beacuse I went in another direction with this engine project.
Harvey 252-339-4560
Springs set up for hydraulic roller cam with 150-160 seat pressure. Heads have the extra holes drilled for the inside head bolt for the Merlin or Dart blocks. $ 1300., plus shipping. Not using beacuse I went in another direction with this engine project.
Harvey 252-339-4560
Last edited by Harvey; 09-15-2011 at 01:33 PM.
#8
Registered
Join Date: Apr 2010
Location: Lake Texoma, OK
Posts: 417
Likes: 0
Received 0 Likes
on
0 Posts
I'm sure this is a stupid question for an builder, but since I'm not I'll ask it. What does "345 intake runner" mean? Head/intake mating surface? Will your heads work on a gen VI 502? thanks...
#9
Registered