Merlin III Iron Heads
#1
Registered
Thread Starter
Join Date: Aug 2011
Posts: 108
Likes: 0
Received 0 Likes
on
0 Posts
Merlin III Iron Heads
345 CC Intake Runners.
These heads have been ported by PRI, and FLOW.
Nothing but the best valves:
Manley 11524 Intakes valve at 2.250" and Manley 11507 Exhaust valves at 1.90".
Crane 99895 dual valve springs
Heads just came from the machine shop, have a fresh valve job, and have been looked over, should be ready to bolt on.
Chamber volume is right at 126cc's
These were perfect on a 572 I was running. Going forced induction and aluminum, so these have to go.
Asking 1100+ the ride. Someone is getting a helluva deal on these. I just stuck 300 into them at the machine shop getting them cleaned up, checked out, and the valve job done. I have pictures available and will try to post them in a bit.
These heads have been ported by PRI, and FLOW.
Nothing but the best valves:
Manley 11524 Intakes valve at 2.250" and Manley 11507 Exhaust valves at 1.90".
Crane 99895 dual valve springs
Heads just came from the machine shop, have a fresh valve job, and have been looked over, should be ready to bolt on.
Chamber volume is right at 126cc's
These were perfect on a 572 I was running. Going forced induction and aluminum, so these have to go.
Asking 1100+ the ride. Someone is getting a helluva deal on these. I just stuck 300 into them at the machine shop getting them cleaned up, checked out, and the valve job done. I have pictures available and will try to post them in a bit.