Repaint Boat Trailer
06-17-2008, 02:11 PM
#11
Gold Member
Gold MemberThread Starter
Join Date: Sep 2005
Location: Missouri
Posts: 1,987
Likes: 0
Received 0 Likes
on
0 Posts
Yep. Imron MSDS sheet 2, 3 & 4 as you said, once the activator is added fresh air only. Nasty.
http://www.performancecoatings.dupon...le=DirectLogin
http://www.performancecoatings.dupon...le=DirectLogin
The only specified respirator for Imron is fresh-air supply. No filters work on cyano. This is why you can't even access information on the product on DuPont's website- they don't want anyone other than professional applicators using it. Body shop supply stores sometimes care but most often don't. they also don't sufficiently warn people about the health hazards of this stuff. If you're using it outside in a well-ventilated area, you will have way less issue.
06-18-2008, 06:26 PM
#13
Registered
Original manufactures do not clean steel enough. There is still mill scale and oil on the steel surfaces. You will have a better longer lasting finish on a blasted trailer than new. It is well worth the time and effort. Be sure to primer as soon as you can after blasting. You may consider brushing inside rails while spraying to get all the inside corners.
06-19-2008, 11:18 PM
#14
Registered
Join Date: Dec 2000
Location: Bell Canyon, CA
Posts: 12,754
Likes: 0
Received 0 Likes
on
0 Posts
Some parts had to be reconstructed (the rear piece with the lights in it). Down to the metal and all re-done.....<$5K Everything!
06-19-2008, 11:20 PM
#15
Registered
Join Date: Dec 2000
Location: Bell Canyon, CA
Posts: 12,754
Likes: 0
Received 0 Likes
on
0 Posts
06-20-2008, 01:33 PM
#16
Gold Member
Gold Member
Join Date: Nov 2003
Location: Colonial Beach, VA
Posts: 580
Likes: 0
Received 0 Likes
on
0 Posts
When I'm spraying catalyzed epoxies and polyesters I tell the neighborhood kids to get on in the house 
.
I friend just did his trailer with Rhinoliner. It looks awesome. He painted the fenders with urethane.
.I friend just did his trailer with Rhinoliner. It looks awesome. He painted the fenders with urethane.
06-24-2008, 09:53 AM
#17
Registered
Join Date: Dec 2000
Location: Bell Canyon, CA
Posts: 12,754
Likes: 0
Received 0 Likes
on
0 Posts
I't turned out to be around $6K, but I had to have a lot redone. New custom fenders, refabricate the rear frame (where the lights are)......lots of rust to remove.
06-24-2008, 10:49 AM
#18
Forum Regulator
VIP Member
Turned out great Nort.
Thread
Thread Starter
Forum
Replies
Last Post
Dave1972
General Boating Discussion
12
02-06-2006 11:37 AM
