C3 Corvette
#51
Platinum Member
Platinum Member
Thread Starter
Going to give these Comp OE style rockers a try so to use the stock valve covers
The following users liked this post:
dykstra (01-20-2021)
#52
Registered
#53
Platinum Member
Platinum Member
Thread Starter
Going to finish the build on the run stand, picking the heads up tomorrow
The following users liked this post:
dykstra (02-06-2021)
#54
Platinum Member
Platinum Member
Thread Starter
the original Rat motor 427
Last edited by F-2 Speedy; 01-22-2021 at 04:44 PM.
#55
Platinum Member
Platinum Member
Thread Starter
finally got the custom length Comp push rods, I upgraded all of it to 3/8 for the higher spring pressure
The following 2 users liked this post by F-2 Speedy:
dykstra (02-06-2021), lucky strike (02-05-2021)
#56
Platinum Member
Platinum Member
Thread Starter
The following users liked this post:
dykstra (02-23-2021)
#57
Platinum Member
Platinum Member
Thread Starter
The following 2 users liked this post by F-2 Speedy:
dykstra (02-23-2021), speicher lane (02-23-2021)
The following 3 users liked this post by lucky strike:
#60
Platinum Member
Platinum Member
Thread Starter