572 Rumble Any1?
#11
Registered
Join Date: Feb 2001
Location: charlotte nc.
Posts: 1,849
Likes: 0
Received 0 Likes
on
0 Posts
#12
Brotherhood #1
![](https://www.offshoreonly.com/forums/images/icons/gold_member_star.gif)
Thread Starter
![Default](/forums/images/icons/icon1.gif)
Hey Mike what do you run for fuel pressure? Also i should have a video tomorrow of it running and also final touches tomorrow talk to you all soon
#14
Brotherhood #1
![](https://www.offshoreonly.com/forums/images/icons/gold_member_star.gif)
Thread Starter
![Default](/forums/images/icons/icon1.gif)
Mike i had ping right when i started to make boost. Not sure if the timing was dead on just because of the light i was using so i retared it a bit. But my main thing is that it blew back threw the carb 3 times. Once when i was around 3k pulling into bristol harbor, After that when i was getting on plane and once just after planing out any ideas????
#17
Registered
Join Date: Feb 2001
Location: charlotte nc.
Posts: 1,849
Likes: 0
Received 0 Likes
on
0 Posts
![Default](/forums/images/icons/icon1.gif)
Rob is right check your fuel psi. also recheck that timing i would start around 30 degrees total if the motor did fine on the dyno with that tune if anything it should be a little rich. also if it backfires it may get a powervalve in the carbs but that will make it rich also
#18
Brotherhood #1
![](https://www.offshoreonly.com/forums/images/icons/gold_member_star.gif)
Thread Starter
![Default](/forums/images/icons/icon1.gif)
Fuel pressure was perfect im thinking the timing was just advanced to much. it does run rich i can tell you that off the bat. just the whole popping think i just dont understand valve to tight? but it happend 3 times out of 1 1/2 once getting on plane once just hitting plane and once cruisin around 3k. it pinged on boost so i etatred the timing.
Thread
Thread Starter
Forum
Replies
Last Post
dreamer
General Boating Discussion
8
11-21-2002 04:12 PM