1HYPER1

Sweet looking dash,all that is missing are the BOOST guages

RaggedEdge

Looks pretty good, but you need to twist those gauges around so they sit level, and heat shrink those wire ends and connectors to keep the moisture out.

Velocity Vector

Thanks Ragged, I see the water temp gauges are off some, do the others look straight to you guy's. I was wondering the same thing about the shrink wrap and I think it would too be a good idea.

I'm curious why they weren't wraped from the factory. I haven't found one piece of shrink wrap since I started the dash. Anyone else see something goofy chime in I'm only doing this once. Thanks

RaggedEdge

Time and Money, they would hate to push the base price up a hundred bucks.

As far as the gauges, just sit in the seat and give them a good eyeballing as you go, so you can adjust before you reach the point you need to take something back out in order to get to them. Not a big deal, I've squeaked a few on most every boat I've owned, easier to do it now, rather than later. Looks good though.

Velocity Vector

Today I took Raggeds advice, went back and put the water proof stretchy rubber tape on all the connections, installed the water temps, oil pressures, tachs and GPS speedo, warning lights, buzzers, fire serpresent light. I can still see over the dash, that's a good thing.
Where should I put the recall switch, before it was on the right hand side where the fuel pressure gauge is now. Any ideas where I should put it besides up my A$$.







I should stagger these scoops, It would make it look even faster at the docks.

Velocity Vector

I did that, I must me cock eyed. HEE!

Pat McPherson

That looks awesome!
Nice work!

I have a few gauges to move around at some point too so I'll be asking for help...

Velocity Vector

Houston, we have contact! I would like to thank everyone for their input and help during the Monster swap. Some pictures of the finished project.
Before

Velocity Vector

007joe

looks great!!