Bought engines today VV
#191
Crazy Energy
Platinum Member
Thread Starter
Join Date: Aug 2007
Location: Oklahoma God's country no one else wants it.
Posts: 4,334
Likes: 0
Received 1 Like
on
1 Post
#193
Registered
Any updates?
#194
Crazy Energy
Platinum Member
Thread Starter
Join Date: Aug 2007
Location: Oklahoma God's country no one else wants it.
Posts: 4,334
Likes: 0
Received 1 Like
on
1 Post
Last I heard they were going to dyno my engines the first of this week, but have not heard anything yet. Still pretty busy this time of year so I guess I'm at their mercy.
#195
Registered
#196
Crazy Energy
Platinum Member
Thread Starter
Join Date: Aug 2007
Location: Oklahoma God's country no one else wants it.
Posts: 4,334
Likes: 0
Received 1 Like
on
1 Post
"OH BOY" Sounds expensive Hyper, I'm calling today to see what is going on, last I heard they were going to dyno the first of this week but have not heard anything. Let me know what I need next, Heee! The best part of all this is when you get to say ..."SAY WHEN"
Last edited by Velocity Vector; 08-15-2008 at 04:16 AM.
#198
Crazy Energy
Platinum Member
Thread Starter
Join Date: Aug 2007
Location: Oklahoma God's country no one else wants it.
Posts: 4,334
Likes: 0
Received 1 Like
on
1 Post
I'm going to sweeten the thread a little. Tell a friend, Winner gets a $100.00!
Look at the parts listed below: ??? POST>>How much is it going to cost for just the labor turn Key??? Taken out the old and putting in the new I want you guy's to take an edcuated guess on how much the labor will end up costing on the project, all I can say is it is $95.00 per hr.
To make it fair I'm staying out. When I get the final bill I will post the winner. Good Luck hope you win!
One guess and make it a good'en
3 Rules:
1. If you go over the total your guess doesn't count!
2. If for some reason there is a tie the earler post will win.
3. Once your $$$ guess is posted you can not edit it. VV
2 - Mercury Supercat race engines $29,000.00
2 - Weldon 1000 HP Fuel pumps $1,400.00
2 – Regulators w/ by-pass Areomotive $500.00
2 - Oil coolers & brackets $500.00
2 - Keith E. Oil pre-lubers $1,400.00
2 - Hardin Marine water separators $440.00
2 - MSD Marine distributors $780.00
2 - MSD high vibration coils $100.00
2 - MDS coil brackets $10.00
2 - MSD sets rpm chips $132.00
2 - MSD insulated plug wires $200.00
2 - Stellings headers $13,000.00
2 - Stellings tailpipes $3,000.00
2 - Air activated switchable mufflers $2,400.00
2 – Hour meter Gauges Livorsi $100.00
2 - Xtreme Billet Aluminum Engine Mounts Rear Side By Side Mount $600.00
2 - Xtreme Billet Aluminum Engine Mounts Front Side By Side Mount $880.00
2 - Billet Aluminum Xtreme MSD 6M-2, Rev Limter & Coil Bracket $270.00
2 - Billet Aluminum Chevy Distributor Hold Down Clamp $80.00
2 - Throttle Bracket King Demon Carburetors $95.00
2 – Wiring harness $278.00
2 - Mercury XR race drives W/ 1" shorties $13,000.00
2 - 15.25 X 34P Mercury Marine props $1,500.00
2 - IMCO 12" Extension boxes $8,000.00
1 - IMCO Tie bars Lower $379.00
2 – IMCO HD gimbal rings and helmets $2,700.00
2 - K-Plane 380 plates $1,800.00
2 - K-plane pumps $500.00
2 - Trim pumps $500.00
4 - Billet 42oz. reserve fluid reservoirs $800.00
2 - Rule 2000 bilge pump $310.00
2 - Dual billet trim reservoirs for pumps Dana Marine $900.00
3 - Billet battery boxes Dana Marine $400.00
2 – XR Drive actuators $548.00
2 – XR drive locks $60.00
2 – Prop Locks $72.00
1 - Piratecom 5 person intercom system W/extreme headsets $2000.00
1 - VHF Radio $585.00
1 - VHF Remote microphone $160.00
1 - VHF antenna $100.00
1 - Ratchet mount $25.00
1 - VHF radio flush mount $25.00
1 - Go Pro video camera $170.00
Look at the parts listed below: ??? POST>>How much is it going to cost for just the labor turn Key??? Taken out the old and putting in the new I want you guy's to take an edcuated guess on how much the labor will end up costing on the project, all I can say is it is $95.00 per hr.
To make it fair I'm staying out. When I get the final bill I will post the winner. Good Luck hope you win!
One guess and make it a good'en
3 Rules:
1. If you go over the total your guess doesn't count!
2. If for some reason there is a tie the earler post will win.
3. Once your $$$ guess is posted you can not edit it. VV
2 - Mercury Supercat race engines $29,000.00
2 - Weldon 1000 HP Fuel pumps $1,400.00
2 – Regulators w/ by-pass Areomotive $500.00
2 - Oil coolers & brackets $500.00
2 - Keith E. Oil pre-lubers $1,400.00
2 - Hardin Marine water separators $440.00
2 - MSD Marine distributors $780.00
2 - MSD high vibration coils $100.00
2 - MDS coil brackets $10.00
2 - MSD sets rpm chips $132.00
2 - MSD insulated plug wires $200.00
2 - Stellings headers $13,000.00
2 - Stellings tailpipes $3,000.00
2 - Air activated switchable mufflers $2,400.00
2 – Hour meter Gauges Livorsi $100.00
2 - Xtreme Billet Aluminum Engine Mounts Rear Side By Side Mount $600.00
2 - Xtreme Billet Aluminum Engine Mounts Front Side By Side Mount $880.00
2 - Billet Aluminum Xtreme MSD 6M-2, Rev Limter & Coil Bracket $270.00
2 - Billet Aluminum Chevy Distributor Hold Down Clamp $80.00
2 - Throttle Bracket King Demon Carburetors $95.00
2 – Wiring harness $278.00
2 - Mercury XR race drives W/ 1" shorties $13,000.00
2 - 15.25 X 34P Mercury Marine props $1,500.00
2 - IMCO 12" Extension boxes $8,000.00
1 - IMCO Tie bars Lower $379.00
2 – IMCO HD gimbal rings and helmets $2,700.00
2 - K-Plane 380 plates $1,800.00
2 - K-plane pumps $500.00
2 - Trim pumps $500.00
4 - Billet 42oz. reserve fluid reservoirs $800.00
2 - Rule 2000 bilge pump $310.00
2 - Dual billet trim reservoirs for pumps Dana Marine $900.00
3 - Billet battery boxes Dana Marine $400.00
2 – XR Drive actuators $548.00
2 – XR drive locks $60.00
2 – Prop Locks $72.00
1 - Piratecom 5 person intercom system W/extreme headsets $2000.00
1 - VHF Radio $585.00
1 - VHF Remote microphone $160.00
1 - VHF antenna $100.00
1 - Ratchet mount $25.00
1 - VHF radio flush mount $25.00
1 - Go Pro video camera $170.00
Last edited by Velocity Vector; 08-16-2008 at 05:19 AM.