454...
#1
Registered
Thread Starter
Join Date: Oct 2004
Location: CHESAPEAKE,VA
Posts: 692
Likes: 0
Received 0 Likes
on
0 Posts
![Default](/forums/images/icons/icon1.gif)
Anyone Looking For A 454 30 Over Gen 4 Rebuilt Ready To Go.
Have Exhaust (cmi)...
454 460 ci
holley carb 830
rpm performer intake
steel crank
4 bolt
srp pistons
dimple rods
crane cam (134241) 534/553 lift 226/236
Have Exhaust (cmi)...
454 460 ci
holley carb 830
rpm performer intake
steel crank
4 bolt
srp pistons
dimple rods
crane cam (134241) 534/553 lift 226/236
Last edited by baja36ft; 06-16-2008 at 06:20 PM.
#3
Registered
Join Date: May 2007
Location: Jamesville, NC
Posts: 134
Likes: 0
Received 0 Likes
on
0 Posts
![Default](/forums/images/icons/icon1.gif)
Good luck. I have a 502 rebuilt with 125 hours complete engine. Did not run it last year. I just cant afford to pay the gas. I only want $3000.00 and I still have it boxed up in my shop. I figured this was cheap and would sell.
#6
Registered
Join Date: May 2007
Location: Jamesville, NC
Posts: 134
Likes: 0
Received 0 Likes
on
0 Posts
![Default](/forums/images/icons/icon1.gif)
I am no motor head but I can tell you I had no problems with the engine. I hit a wake to hard one day and found out my stringers had begin to rotten so I pulled the motor and rebuilt the entire engine compartment and transom out of composite board. I never put the motor back in. Ran one time last year and has been sitting in my shop since. My number is 252-217-3407.
Thread
Thread Starter
Forum
Replies
Last Post
lhousman
General Q & A
13
03-05-2002 01:47 AM