WTB: Y-Pipe block off plate
#1
Registered
Thread Starter
Join Date: Oct 2006
Location: Michigan
Posts: 1,449
Likes: 0
Received 0 Likes
on
0 Posts
![Default](/forums/images/icons/icon1.gif)
Looking for a block off plate for a bravo 1. If anyone has one ar can point me in the right direction to buy on. Also how prone are these to leak as I am assuming it will be difficult to get to once engine is back in.
#2
Registered
![Default](/forums/images/icons/icon1.gif)
I have one it has an o ring to seal it $50 with bolts
#3
Registered
Join Date: Apr 2010
Location: SE FL
Posts: 1,459
Likes: 0
Received 0 Likes
on
0 Posts
![Default](/forums/images/icons/icon1.gif)
I have a Teague block off plate that does not work with the IMCO extension box. If you your are just blocking it off it will work fine.
I think it was $35 for the plate... if you are interested I will get the exact price. It was only on the lower for 10 minutes.
I think it was $35 for the plate... if you are interested I will get the exact price. It was only on the lower for 10 minutes.
#4
Registered
Thread Starter
Join Date: Oct 2006
Location: Michigan
Posts: 1,449
Likes: 0
Received 0 Likes
on
0 Posts
#5
Registered
Join Date: Apr 2010
Location: SE FL
Posts: 1,459
Likes: 0
Received 0 Likes
on
0 Posts
![Default](/forums/images/icons/icon1.gif)
I do not know... I told them what I was going to use it with and they said it would work.
It is too wide for the key hole which prevented the gimble housing mounting. The bottom was just a little too wide. I am sure if I grind it it'll fit but I really don't want to.
I don't know if Stelling would know the answer, I would say call Teague, but they did not have the correct answer for me.... unless they make two different plates.
It is too wide for the key hole which prevented the gimble housing mounting. The bottom was just a little too wide. I am sure if I grind it it'll fit but I really don't want to.
I don't know if Stelling would know the answer, I would say call Teague, but they did not have the correct answer for me.... unless they make two different plates.
#7
Registered
Thread Starter
Join Date: Oct 2006
Location: Michigan
Posts: 1,449
Likes: 0
Received 0 Likes
on
0 Posts
#8
Registered
![Default](/forums/images/icons/icon1.gif)
I have 2 with bolts,let me know if you still need one