Libertarian

Can be running or not, good parts preferrable. Must be 4bolt mains. No Junk. Let me know what you have. I need them for a buildup project. Thanks

Precision

I have a few, are you looking for 350, or 400?

kgz3

i have a pair of running take outs 350ci-365hp holley carbs msd ign gill exh less than 20 hr on motors if interested call me #309-925-4620 karl if you dont get me leave massage & number

Libertarian

Would rather have 4bolt main 350s, but if you have a pair of 400s, might be interested in those also.

O.C.Barry

I have 2 4 bolt main small blocks:

Supercharged small block Chevy engines with DYNO TIME ONLY

Here are some engine specs:

Dyno 487.3 Horsepower 486.7 FT LBS Torque DYNO TIME ONLY The boost is pretty low, you can change the pulley and up the HP easily. We built these to race in the 28 Cigarette so they are bullet proof and there was no expense spared. I have about $12,5K+ in each in them.

ALL NEW: Scat Cranks, WISECO Blower pistons, H-Beam connecting rods, polished WEIAND 177 superchargers, Quick Fuel 850 CFM carbs, JESEL rocker systems, Smith brothers custom push rods, MSD marine distributers. Engines are painted plum crazy purple.

The heads are World Products S/R. No race fuel is needed, we built the engines to run all day long on 93 octane. The boost is right at 5 pounds, which is very conservative for a small block, we built these to race and live. The engines are balanced. Starters, flywheels, and crank pulleys come with the engines.

Engines were built by Steve Conniff of Burtonsville Performance Machine. Steve builds many performance car and boat engines and built the 2009 NHRA stock eliminator World Champion's engine. Steve has his own 100+ MPH Non-Stepped 33 Fountain.

I’ll take $6,200 each, (which is half of cost) or $12,100 for the pair.

Barry DeBald - Home phone: 410-256-2332