WTB: BBC Hyd. Roller Lifters Retrofit
#1
Registered
Thread Starter
WTB: BBC Hyd. Roller Lifters Retrofit
Here is the deal. I have Flat tappet cam in my 454 (at machine shop now) and wanting roller cam. Funds do not justify the conversion (+$1,000) mainly because lifter cost.
Anybody have a set of good quality Hyd. Roller Lifters that will work for a reasonable price?
Also could be interested in good used roller camshaft.
The flat tappet cam I am looking at is Crane 132561 for reference.
Thank you in advance.
Anybody have a set of good quality Hyd. Roller Lifters that will work for a reasonable price?
Also could be interested in good used roller camshaft.
The flat tappet cam I am looking at is Crane 132561 for reference.
Thank you in advance.
#3
Registered
Thread Starter
I currently have Stainless Marine Bravo Standard Risers. Before I install in boat I am planning to extend both the inner and outer tubes of risers as long as practical to help control reversion. So no not dry. How about lifters?
Thank you anyways.
Thank you anyways.
#5
Platinum Member
Platinum Member
I take the morel lifters from my blower motor and retire them every 100 hours when I refresh it just for good measure, I have a set that worked perfect still I would sell for 120$ shipped to your door if your in the US
#6
Registered
Thread Starter
That is the type of response I was looking.
Very interested.
Couple of questions,
What is the part #?
Will these work "as is" in my Mark 4 BBC block (was flat tappet) i.e. no machine work?
Std. height and bore?
I see some are for very high rpm only, are these of that variety?
Sorry about all the dumb questions just don't want to go full speed in the wrong direction.
Thank you.
Very interested.
Couple of questions,
What is the part #?
Will these work "as is" in my Mark 4 BBC block (was flat tappet) i.e. no machine work?
Std. height and bore?
I see some are for very high rpm only, are these of that variety?
Sorry about all the dumb questions just don't want to go full speed in the wrong direction.
Thank you.
#7
Platinum Member
Platinum Member
I have 2 sets that were both in my mk4 style Dart big m, they are a drop in for a mk 4, std height, std lifter bore, one set was on a cam with 590 lift, the other set 638, they are not the hi rev version as when I bought these they werent out yet, not sure on the part number anymore, I will look and see if they are marked at all. Just ran out and looked, no markings on them, I also have a Cam motion mk 4 style hyd cam that I bought from Tyler Crocket and ran a few years, its 227/234 at .050 and I think its .590 lift, say 227/234-14 on it, would throw it in for 110$ too, no damage at all, I will verify lobe lift
Last edited by articfriends; 10-05-2015 at 01:49 PM.