Tie bar
#1
Registered
Thread Starter
Tie bar
I have a 32' . Need at least 36"
#3
Registered
Thread Starter
Something in the 1.50-1.75" diameter range..
#4
Registered
I know a local marina went to a prop repair shop that supplied shafts to the inboard cruiser market...
The shop made the center section of the tie-bar from a cut off from a previous prop shaft job and cut the threads for the clevis' ends... a lot cheaper and faster than ordering a tie bar assembly as its just basic machining to punch the order out the door.
Something to consider..
The shop made the center section of the tie-bar from a cut off from a previous prop shaft job and cut the threads for the clevis' ends... a lot cheaper and faster than ordering a tie bar assembly as its just basic machining to punch the order out the door.
Something to consider..
#5
VIP Member
VIP Member
Another one to look at is Zeiger Performance Marine. (Located in Sandusky, OH)
Speedmaster 6 Tie Bars & Mounts @ Everett Performance - Zeiger Marine Products Official Site
Speedmaster 6 Tie Bars & Mounts @ Everett Performance - Zeiger Marine Products Official Site