Ssm #5
02-03-2024, 01:39 PM
#5
Registered
I have a complete complete setup for a big shaft 4
1.41RH comes with drive, transom assembly, 7” Latham rams and wing plates, 15” extension box, driveline carrier, driveshaft, Huber 1550, dampener plate, merc dual cooler bellhousing and 1 cooler (somehow the other cooler was lost during the shop move, Ssm extension box transom plate. Everything has sub 30 hours. Drive has 1 hour since complete rebuild every piece from Brian Jackson. Transom assembly and drive has nice paint. And I’ll throw in 1 16.5x26 4 blade a 16.5x27 3 blade a 16x27x4 blade prop and an adapter to a merc square bore propeller. Take it all 12,500$. I’ll even palletize it and have a shipper that’s reasonable.
id even swap it out if you don’t want the transmission and want a scs zero drag crash box instead I’d do it for the same price.
1.41RH comes with drive, transom assembly, 7” Latham rams and wing plates, 15” extension box, driveline carrier, driveshaft, Huber 1550, dampener plate, merc dual cooler bellhousing and 1 cooler (somehow the other cooler was lost during the shop move, Ssm extension box transom plate. Everything has sub 30 hours. Drive has 1 hour since complete rebuild every piece from Brian Jackson. Transom assembly and drive has nice paint. And I’ll throw in 1 16.5x26 4 blade a 16.5x27 3 blade a 16x27x4 blade prop and an adapter to a merc square bore propeller. Take it all 12,500$. I’ll even palletize it and have a shipper that’s reasonable.
id even swap it out if you don’t want the transmission and want a scs zero drag crash box instead I’d do it for the same price.
Last edited by mickeymcclgn; 02-03-2024 at 02:19 PM.
The following 2 users liked this post by mickeymcclgn:
21rc (02-05-2024), AZ Lineman (Yesterday)
02-05-2024, 03:49 PM
#6
Registered
Thread Starter
Mickeymccign, really looking for a 5 or a 3A. I don't know if a 4 will take the power I have. Appreciate the offer.
Last edited by 21rc; 02-05-2024 at 03:51 PM.
02-05-2024, 04:07 PM
#7
Platinum Member
Platinum Member
There are #5's and 3A's in the classifieds
02-05-2024, 04:39 PM
#8
Registered
How much power are you putting through it? If you’re putting that much power through it just go 6, parts are becoming more reasonable. I’ve reliably put 1,000 and 1200 through this drive in a single engine 28’ boat for the 10 years I’ve owned it and the 15 years the guy before me had it. Rebuild was due to water intrusion.
The following users liked this post:
21rc (02-10-2024)
02-10-2024, 04:04 PM
#9
Registered
Thread Starter
How much power are you putting through it? If you’re putting that much power through it just go 6, parts are becoming more reasonable. I’ve reliably put 1,000 and 1200 through this drive in a single engine 28’ boat for the 10 years I’ve owned it and the 15 years the guy before me had it. Rebuild was due to water intrusion.
